Author Topic: Caliber question 33-78??  (Read 13834 times)

tombogan03884

  • Guest
Re: Caliber question 33-78??
« Reply #10 on: October 18, 2008, 11:46:54 PM »
I'm going to develop a "Wildcat" cartridge, the 1010-223, it will be a 62 grain .223 bullet in a necked down 40mm caseing. I'm thinking a compression load of IMR 4350 I think about 3500 grains should do the trick.
Hey MB, want to try a REAL Veloceraptor zapper  ;D

Big Frank

  • NRA Benefactor Member
  • Top Forum Member
  • *****
  • Posts: 9463
  • DRTV Ranger
  • Liked:
  • Likes Given: 1048
Re: Caliber question 33-78??
« Reply #11 on: October 18, 2008, 11:52:12 PM »
Another short magnum?  ;)  That's almost as good as the .50 BMG necked down to take a Victrola phonograph needle. The diamond tip gives it great penetration.  ;D
""It may be laid down as a primary position, and the basis of our system, that every Citizen who enjoys the protection of a free Government, owes not only a proportion of his property, but even his personal services to the defence of it, and consequently that the Citizens of America (with a few legal and official exceptions) from 18 to 50 Years of Age should be borne on the Militia Rolls, provided with uniform Arms, and so far accustomed to the use of them, that the Total strength of the Country might be called forth at a Short Notice on any very interesting Emergency." - George Washington. Letter to Alexander Hamilton, Friday, May 02, 1783

THE RIGHT TO BUY WEAPONS IS THE RIGHT TO BE FREE - A. E. van Vogt, The Weapon Shops of Isher

tombogan03884

  • Guest
Re: Caliber question 33-78??
« Reply #12 on: October 18, 2008, 11:55:08 PM »
Another short magnum?  ;)  That's almost as good as the .50 BMG necked down to take a Victrola phonograph needle. The diamond tip gives it great penetration.  ;D

Can I get them in Hollow point ?  ;D

 

SMF spam blocked by CleanTalk